all-sun Automotive Cable Wire Tracker Car Tracer Finder Test Short & Open DC 6~42 Volts

Please Note: This product set needs two batteries. Please install 9V 6F22 battery in both Receiver & Transmitter.

This instrument is designed to identify and trace wires or cables without damaging the insulation.
You can also use it in checking for short circuit and loacting open circuit and so on.
There are a Sender and a Receiver included in the instrument.

HOW TO USE THE PROBE?
The probe of the Receiver is built of coiled steel and may be bent as needed, in order to reach wires in ongested or difficult areas.
Depending on the circuit characteristic and sensitivity settings, the probe will pick up the signal from  the wire in a range of positions.
However, for the best possible  range the Receiver's probe tip (black cap) should be positioned perpendicular (at 90o) to the wire being traced and either above or below it.

SPECIFICATIONS:
Receiver:
On/Off button
Test button
Probe length: 7" flexible probe
Sender:
Tone/Off/Cont (Continuity) switch
Tone/Cont (Continuity) LEDs
Red and black test leads cable (61cm length, approximate)
Receiver Dimensions: 38.5 x 4 x 2.3cm (H x W x D, approximate)
Sender Dimensions: 6.5 x 5.6 x 2.1cm (H x W x D, approximate)
DC Voltage: Operates from 6 to 42 volts
Power : 2x9V battery (6F22) (Battery not provided by seller)

PACKAGE:
1 x Automotive Short and Open Finder Sender
1 x Automotive Short and Open Finder Reciever(with carrying bag)
English User Manual
Standard Factory Packaging

APPLICATION:
Checking for short circuit,Loating open circuit,Wire identification, Wire traceing,etc.


Please Note: This product set needs two batteries. Please install 9V 6F22 battery in both Receiver & Transmitter.