OMRON H3YN-41 200 to 230VAC Solid-state Timer (Long-time range model)(0.1min to 10h)(4PDT) NN

[Model]Long-time range model(0.1 min to 10 h)
[Time-limit contact]4PDT
[Supply voltage]
200 to 230VAC
Note: 1. Sockets and Hold-down Clips are not included with the H3YN.
They must be ordered separately.
2. Only models with 24-VDC power supply are available.
3. Use the H3YN-4 or H3YN-41 Series when switching micro loads,
and use the H3YN-4-Z or H3YN-41-Z Series when switching even smaller loads.

Ratings
[Item]H3YN-41
[Time ranges]0.1 min to 10 h(1 min,10 min,1 h,or 10 h max. selectable)
[Rated supply voltage *4 *5]200 to 230VAC *1
[Pin type]Plug-in
[Operating mode]On-delay,interval,flicker OFF start(selectable withDIP switch)
[Operating voltage range]85% to 110% of rated supply voltage(12 VDC: 90%to 110% of rated supply voltage)*2
[Reset voltage]10% min. of rated supply voltage *3
[Power consumption]100 to 120 VAC:
Relay ON: Approx. 1.8 VA(1.6 W)at 120 VAC,60 Hz
Relay OFF: Approx. 1 VA(0.6 W)at 120 VAC,60 Hz
[Control outputs]3 A at 250 VAC,resistive load(cos phi = 1)
H3YN-4/-41 series: The minimum applicable load is 1 mA at 1 VDC(P referencevalue).
Contact materials: Au-clad + Ag-alloy
*1. Do not use the output from an inverter as the power supply.
Refer to Safety Precautions for All Times for details.
*2. When using the H3YN continuously in any place where the ambient temperatureisin a range of 45 deg.(C)to 50 deg.(C),
supply 90% to 110% of the rated supply voltages(supply 95% to 110% with12 VDC type).
*3. Set the reset voltage as follows to ensure proper resetting.
100 to 120 VAC: 10 VAC max.
200 to 230 VAC: 20 VAC max.
100 to 110 VDC: 10 VDC max.
*4. Refer to Safety Precautions for All Timers when combining the Timerwithan AC 2-wire proximity sensor.
*5. A diode to prevent reverse voltages is provided only on models withaDC power supply.