OMRON H3YN-21 AC200/230V Solid-state Timer (Long-time range model)(0.1min to 10h)(DPDT)(AC) NN

[Model]Long-time range model(0.1 min to 10h)
[Time-limit contact]DPDT
[Supply voltage]100 to 120 VAC,
[Item]H3YN-21
[Time ranges]0.1 min to 10h(1min,10min,1h,10h max. selectable)
[Rated supply voltage]100 to 120VAC,200 to 230VAC(50/60Hz)

Note: 1. Sockets and Hold-down Clips are not included with the H3YN.
They must be ordered separately.
2. Only models with 24-VDC power supply are available.

[Time ranges] 0.1 min to 10h (1min, 10min, 1h, 10h max. selectable)
[Rated supply voltage *4 *5] 12VDC, 24VDC, 100 to 110VDC *1
[Pin type] Plug-in
[Operating mode] On-delay, interval, flicker OFF start (selectable with DIP switch)
[Operating voltage range] 85% to 110% of rated supply voltage
(12 VDC: 90% to 110% of rated supply voltage) *2
[Reset voltage] 10% min. of rated supply voltage *3
[Power consumption] 12 VDC:
Relay ON: Approx. 1.1 W at 12 VDC
Relay OFF: Approx. 0.1 W at 12 VDC
[Control outputs] 5 A at 250 VAC, resistive load (cos phi = 1)
The minimum applicable load is 1 mA at 5 VDC (P reference value).
Contact materials: Ag
*1. Single-phase, full-wave-rectified power supplies can be used.
*2. When using the H3YN continuously in any place where the ambient temperatureis in a range of 45 deg.(C) to 50 deg.(C),
supply 90% to 110% of the rated supply voltages (supply 95% to 110% with 12 VDC type).
*3. Set the reset voltage as follows to ensure proper resetting.
100 to 120 VAC: 10 VAC max.
200 to 230 VAC: 20 VAC max.
100 to 110 VDC: 10 VDC max.
*4. Refer to Safety Precautions for All Timers when combining the Timerwith an AC 2-wire proximity sensor.
*5. A diode to prevent reverse voltages is provided only on models witha DC power supply.