Fluke 726 Precision Multifunction Process Calibrator

Fluke 726 precision multifunction process calibrator is designed specifically for the Process industry with broad workload coverage, calibration power and unsurpassed accuracy in mind. The 726 measures and sources almost all process parameters and can calibrate almost anything. The 726 will also interpret results without the help of a calculator and store measurement data for later analysis. Measure or source pressure using any of 29 Fluke 700Pxx pressure modules. Source mA with simultaneous pressure measurement to conduct valve and I/P tests. Integrated pressure switch test allows you to capture the set, reset and dead band of a switch. Memory storage for up to 8 calibration results, return stored calibration data from the field for later analysis. Transmitter error percent calculation, interpret calibration results without a calculator. Perform fast linearity tests with auto step and auto ramp features. Power transmitters during test using 24 V loop supply and simultaneous mA measurement. Store frequently-used test setups for later use. Frequency totalizer and frequency pulse train source mode for enhanced flowmeter testing. HART mode inserts 250 ohm resistor in mA measure and source for compatibility with HART instrumentation. Custom RTD curves, add calibration constants for certified RTD probes for enhanced temperature measurement. New voltage input protection design for improved reliability. 3000 m operating altitude. EN 61010-1:1993, ANSI/ISA S82.01-1994; CAN/CSA C22.2 No 1010.1:1992 approved. Runs on 4 AA alkaline batteries. Current DC: 24 mA 0.01 percent + 2 mA. Resistance: 0.0 to 4000 O +/- 0.015 percent. Storage temperature: -20 degrees C to +71 degrees C. 726 including: 1 set of AC72 alligator clips, 1 set of stackable test leads, 1 set of TL 75 test leads, user manuals and NIST- traceable calibration report and data.