OBD Simulator - J1939 Simulator - ECU Simulator - MINI Version 502 - Current Measurement Display - Voltage Measurement Display - With Automatic Test Function

OBD MINI502 simulator is a simulation of the vehicle OBD bus protocol, commercial vehicle J1939 simulator device.With dynamic simulation engine parameters;LCD display content main parameters in real time.
This equipment is mainly by 16 pin vehicles OBD interface, connected with external diagnostic test equipment.
Its included CAN physical interface, KWP physical interface, power supply, etc.
Able to dial the code switch select vehicles of different modes of OBD / 1939 agreement.
OBD key data characteristics are as follows:
1.Supports real-time Data flow Mode1 Live Data
2.Support trouble-free code model, a fault code mode, fault code function Mode3, Mode4
3.Support to Freeze the data Frame Mode2 Freeze Frame
4.Support Vehicle VIN code and other Vehicle Information, Mode9 Vehicle Information
5.Support USB output debugging information, it is recommended to use SecureCRT view
6.The main dynamic parameters of the knob to adjust
7.LCD display the current parameters and state
J1939 key data characteristics are as follows:
1.29-1250 BPS extension frames:
2.the real-time data sent unsolicited
3.PGN 65262 engine data
4.PGN 65269 outside conditions
5.61444 electronic engine controller 1 PGN
6.PGN 2 61443 electronic engine controller
7.PGN 65132 vehicle traveling data recorder
A simple test work instructions:  
a. OBD work mode setting, all switch to the right, the CAN BUS switch to the left, set up to simulate the vehicle CAN BUS BUS (typical) vehicle.
b. Plugged into a power supply, open the power switch,
c. Insert the OBD device under test, observation NET light and T/R to send and receive signals.
d. After the OBD two-way communication to establish a connection, a.net indicator, the LCD display shows the Connect.At the same time have a T/R to send and receive.