Electrical Testing - Page 836

Manufacturer: RioRand Brand: RioRand Model: RRAPLQGASRAB

Technical Parameters: Display color: Red+Red Display mode: Dual 0.28" LED digital 4 bit tube Refresh rate: About 200 ms/time Dimenions: 48 x 29 x 26 mm (L*W* H) Cutting size: 45 x 26 mm (L*W) Supply voltage: DC 3.5-28V Lead wire length: 14 cm (5-wires) Measurement range: DC 0-999.9mA-3.000A(current); 0.00-33.00V(voltage) Operation temperature: -10 degrees~65 degrees Measurement accuracy: ± (0.3% + 2 digits) Net weight : 22g Display description: Voltage measurement range:0.00-33.00V; the minimum resolution is 10mV Current measurement range: 0-999.9mA-3.000A. when the measuring current is below 1A, it display ***.*mA,the resolusion is 0.1mA; when the measuring current is higher than 1A, it display *.***A,the resolusion is 1mA; Wiring Instruction: RED(VCC): Power input+, 3.5-28V (NOTE: If the measuring signal is lower than 28V and have abundant power supply, it can be used as power supply for the meter. black wire and yellow wire are contacted together to use) Black(GND): Power input- , Measurement signal- (3.5-28V) Yellow(VIN): Measurement signal+ (0-33.00V) RED(I+): Current input+ (in series in Power Supply Negative or Load Negative) Black(I-): Current input- (in series in Power Supply Negative or Load Negative) Package include: 1x 0-33.00V/0-3.000A Volt Amp Meter

Manufacturer: RioRand Brand: RioRand Model: RRAPLFMAA

Features: Cutting size:45.5mm x 26.5mm Dimensions: 48mm x 29mm x 21mm Range: DC 0-50.0A Power Supply: DC 7-30V (2 wires) Display: Three 0.56 " LED digital tube Display Color: Blue Refresh rate: about 300mS / times Accuracy: 1 %(+/- 2 digit) (Measuring 75mv) Note: Common ground design，the ammeter can only series connection between the test equipment negative and the test equipment power supply negative Recommend to use a separate isolated power supply Package Includes: 1x Digital Ammeter 1x Current Shunt

Manufacturer: Zhangzhou Eastern Intelligent Meter Co. Brand: all-sun

The tester uses neon lamps to indicate voltage produced on a fence line or by a fence controller. It is designed for a low impedance and standard duty fence controllers. Product Features: It is designed for a low impedance and standard duty fence controllers. The tester uses neon lamps to indicate voltage produced on a fence line or by a fence controller. Povide a general voltage only NOT the reading directly, but effective and useful in application. Measurement Range is from 2kV to 9kV. All the lights will be lighted when the it measured over Small size and portable to apply. Operation Instruction 1.Insert the probe in ground using the insulated grip . 2.Attaching the test hook to wire fence. To avoid electric shock, do not touch any conductor (such as the test hook, the fence). 3.The neon lamps light to indicate the voltage. 4.If no neon lamp lights, the cause may be one of the following: A. The probe or test hook's connection is loos. B. The fence has electrical problems. C. The voltage under test is less than 2000V. 5.Remove the test hook from the fence and the probe from ground. Specification Measurement Range: 2000V to 9000v Operating Environment: 0℃ to 40℃ Relative humidity< 80% Storage Environment: -20℃ to 50℃ , Relative humidity< 85% Weight: about 67g

Manufacturer: Amprobe Brand: Amprobe Model: TL1500

The Amprobe TL1500 test lead set contains two silicone-insulated lead wires, two standard probe tips, two alligator clips, and two spade lugs for connecting a compatible electrical test meter to a device in electrical testing applications. The 48" lead wires have silicone insulation to protect hands from shock and heat. The silicone insulation resists melting in hot environments and becoming brittle in cold ones, and it maintains flexibility better than polyvinyl chloride (PVC) insulation. The standard probe tips are held against the conductor during testing. The alligator clips (also called crocodile clips) have teeth that grip the conductor to provide a more secure, hands-free connection than the test probe tips. The clips are 3.15" long and have a 0.30" jaw opening. The spade lugs clamp to conductors with compression nuts or screws. The lead The lead wires can be used with testing devices that have universal 4 mm jacks. The kit meets International Electrotechnical Commission (IEC) safety standard 61010 and is certified for category IV installations up to 1,500V, which covers measurements at the source of the low-voltage supply, such as electricity meters and overcurrent protection devices). It also conforms to applicable European Conformity (CE) directives. The kit comes with a soft folding carrying case with a Velcro closure and pockets for organizing probes and wires. Folded, the pouch measures 4.5 x 7.0 x 0.25 inches (H x W x D). Unfolded, it measures 4.5 x 16.0 x 0.25 inches. (H is height, the vertical distance from the lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.)A test probe, test lead, test prod, or scope probe transmits an electrical signal to a testing device for display and analysis. Designs range from simple test leads with probe-style or clamp-on tips to more complex oscilloscope probes and current detectors. Some test probes, such as basic test leads, have wires with tips for connecting to test equipment. O...

Manufacturer: HOTSYSTEM Brand: HOTSYSTEM

Fitment: Universal Fit Any Car Models Feature: 1. Condition:100% New in Box & Good Quality 2. Diameter:2"/52mmbr> 3. Red LED illuminated needles 4. LED super white display 5.Application:All Car Models Listed in 6.Features:Smoke tint lens during the day,Clear and bright LED Display during the night. 7.Add a racing look and feel to your ride,High quality and light weight 8.Easy Installation With Users Manual In English 9. Professional installation is Highly Recommended 10. Exactly same as the picture 11. Black line to (-),Red line to (+),Green line to engine signal line. Package includes: 1 x Universal 2" 52mm Tachometer Gauge 1 x Users Manual In English

Manufacturer: RioRand Brand: RioRand Model: RRLSKJAAEWQQW

Features: Dual LED: Red voltage, Blue current, Display Voltage Current at same time this panel meter is common ground design, it means that the ( measure ground wire) and (power supply ground) is common ground. Power Supply DC 4.5-30V. With reverse polarity protection, but the max power supply can not exceed 30VDC. Specific: Power Supply (Measure Voltage): DC 4.5-30V voltage < 10V, resolution: 0.01V voltage >= 10V, resolution: 0.1V Measure Current: 0-50A forward current ( need an extra 50A shunt for measuring current ) Current Resolution: 0.1A Operating Current:

Manufacturer: Elenco Electronics Inc Brand: Elenco Model: LP-525K

The LP-525K Logic Probe kit is a convenient and precise instrument for use in the measurement of logic circuits. It displays logic levels (high or low), and voltage transients down to 25 nanoseconds. The LED readouts provide instant response to the logic state. Large PC board and detailed manual for fast and easy construction. For 30 years Elenco has been using their strong engineering and design skills to develop reliable, affordable electronic test equipment, tools, and educational kits. SOLDERING REQUIRED - ASSEMBLY REQUIREDSPECIFICATIONS - Input Impedance: 1MΩ - Input Overload Protection: 35V DC continuous - Thresholds: Logic 1: TTL 2.3 + .25V - Logic 0: 0.80V + .1V - CMOS: 70% Vcc 30% Vcc - Response better than: 25 nanoseconds - Pulse Detector: 1.5 millisecond pulse stretcher - Power Requirements: 5V Vcc @ 30mA - 15V Vcc @ 40mA - Operating Temperature: 0 degrees C to +40 degrees C - SOLDERING AND ASSEMBLY REQUIRED

Manufacturer: GEREE Brand: GEREE Color: Three Hole Panel

Specifications: - Cigarette Lighter Socket: Can be used to light cigarettes: No Input Voltage: DC 12V / 20A Dual USB Charger Interface: 2 Input Voltage: 12 - 24V Output Voltage: DC 5V USB Output 1 Current: 2.1A USB Output 2 Current: 1A Indicator: Blue LED - Voltage Meter: Input: DC 5 - 30V Display: 3-bit Blue LED Digital Display Material: ABS Plastic Color: Black Weight: 0.086kg/ 0.039pound Dimension: 152x 43 x 40mm/ 5.98 x 1.69 x 1.57inch Package include: 1 * Universal 12-24V Car Auto Boat Caravan Cigarette Light Socket Dual USB Power Adapter Charger with LED Digital Voltmeter (Black) 4 * Mounting Screws 6 * Waterproof Insulated Terminals

Manufacturer: GE Brand: GE

Brand New OEM! GE Part 90 Day Warranty! Geniune Replacement Part

Manufacturer: DROK Brand: DROK Model: 100083

Features: Dimensions: 79 x 42 x 27 mm Cutting size: 76 x 39.5 mm Operating voltage: DC +5 V +/- 0.5 Operating Current: