Hioki CM7290 AC/DC Current Sensor Display Unit

Hioki CM7290 Display Unit for CT7000 Series Current Sensors Hioki CM7290 Display Unit for CT7000 Series Current Sensors ×   Display and Output Unit for the CT7600 and CT7700 Series AC/DC Current Sensors   Hioki clamp on meters are best-in-class measuring devices incorporating Hioki's expertise in current sensing technology. The CM7290 is the display and output unit for the CT7600 and CT7700 AC/DC Current Sensor series, creating a standalone clamp meter for field use or enabling waveform signals to be output to a Hioki memory recorder or logger for further analysis. The CM7290 Display Unit is to be used with a current sensor equipped with a Hioki PL14 output connector. It will automatically recognize the current sensor when it is connected, and the range and output rate will be automatically set. Set the measurement mode to AC or DC so that the unit can display or output values.   The unit supports simultaneous dual displays - for example, of the measured value and output rate during output, or of the current measured value and maximum value. You can clamp the sensor in high or confined locations, and view the display close at hand. And even when you're in low-light conditions, the backlight feature will allow easier reading of displayed values.   With the optional output cord, waveforms, rms vales and so forth can be output in analog form to a recorder, logger or power meter for waveform observation, long-term recording, power analysis or similar application.   Supports 2 power sources - AC adapter and batteries - for prolonged measurement. The unit can be turned on by powering an AC adapter, so installation into other devices is made possible