NOBLE HARDWARE Digital Indicator 0-12.7mm/0.5"

Resolution: digital indicator: 0.01mm/0.0005＂, 0.01mm/0.001＂ Digital micro-indicator:0.001mm/0.00005＂ Measuring range: digital indicator: 0 ~ 12.7mm/0.5＂, 0~25.4mm/1＂ Digital micro-indicator: 0~5mm/0~0.2＂,0~12.7mm/0.5＂,0~25.4mm/1＂ Power: one sliver oxide batter (SR44) with work voltage 1.5v.

Operating temperature: 0℃~40℃
Storage temperature:-20℃~70℃
Relative humidity:≦80%
Application instruction for digital indicator important

1. The response speed: ≦0.5m/s
2. Avoid shocks, impact, dropping etc.; otherwise it will damage the appearance and precision
3.Keep indicator face clean, prevent liquid from getting into inside.
4. Do not remove output connector lid without using output interface. Output en should never be connected with metal. Doing so could damage your indicator.
5. Do not connect any part of digital indicator with voltage; otherwise it will damage the circuit.
6. Must take out the battery if not in use for a long time Usages of type II：Clean the contact point and spindle with a soft cloth before using. Press the in/mm switch or push the spindle.The .00mm or .000mm display appears,the indicator is now ready for measurement.
Usages of the "M" button;

Display holding:press "M" button, "H" appears and display is holding.
Fast display:press "M" button, "H" appears and press zero button, "F.T" appears,and now display is fast. Press "M" button to end fast display after measuring and "F.T" disappear. Fast tracing of maximum value: Button, "HMAX" appears,then press zero-setting button, "F.T MAX" appears and now is tracing of maximum value. Press "M" button to end tracing of maximum value after measuring and "F.T MIN" disappear. d.Fast tracing of minimum value: press three times "M" button,"HMIN" appears,then press zero-setting button,"F.T MIN" appears and now is tracing of minimum value after measuring and "F.T MIN" disappear.