Kyoritsu 2003A Digital Clamp-Meter, 2000A AC/DC, Conductors to 55mm, Voltage and Resistance Measurement

The Kyoritsu 2003A digital clamp-meter is an average-sensing, auto-ranging multimeter for measuring current, voltage, and resistance in electrical testing applications. It has a clamp that measures AC (alternating current) and DC (direct current) to 2,000A (amperes). The clamp has two jaws that can close around an electrical conductor up to 55mm (2.16 inches) in diameter to measure current without touching or interrupting the circuit. A set of test leads is included for measuring AC voltage to 750V, DC voltage to 600V, and resistance to 4,000Ω (ohms). The meter has a rotary switch to select the property to measure, and a 4,000-count LCD. The maximum function displays the highest reading measured during a 400ms (millisecond) sample. To aid documentation of readings and capture readings in tight spaces, the data hold function keeps the most recent reading on the display after disconnecting from the circuit. A continuity buzzer confirms that the circuit conducts electricity. For long-term monitoring of current, the meter comes with an output plug for attaching to a recording device (sold separately). The unit operates on two 1.5V AA batteries, and turns off automatically after 10 minutes of non-use to conserve battery life. It has a low-battery indicator that signals when the battery needs to be replaced.

This average-sensing, also called average responding or mean value, meter provides accurate readings when measuring linear loads, such as standard induction motors and incandescent lights, where the current or voltage has a sinusoidal waveform. It is auto-ranging, so it automatically selects the appropriate operating range for the property being measured. Accuracy and resolution specifications vary according to the range being measured. The meter meets IEC (International Electrotechnical Commission) safety standards 61010-1, 61010-031, and 61010-2-032, and is rated for CAT (category) IV installations to 600 volts, which covers equipment at the origin of the installation, such as electricity meters and primary over-current protection equipment , and CAT III installations to 1,000V, which covers equipment in fixed installations, such as switches in the fixed installation and some industrial equipment that is permanently connected to the fixed installation. It has CE (European Conformity) marking. The unit comes with a carrying case.

Specifications

H is height, the vertical distance from lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.

Clamp-meters, also called clamp-on meters, have two jaws that fit around a conductor to measure electrical current without cutting through wires, or touching or interrupting the electrical circuit. Available in handheld or benchtop models, clamp-meters diagnose problems in electrical equipment, wiring, and power supplies. All clamp-meters test for current. Some come with test leads and inputs for measuring voltage, capacitance, and resistance. They display information either in analog or digital form. Factors that influence meter choice include the electrical properties to be measured, the anticipated range of results, and the desired level of protection against transient voltage. Safety ratings are based on International Electrotechnical Commission (IEC) standards for low-voltage test equipment. IEC 61010 delineates four overvoltage installation categories. In general, a meter with a category IV rating will provide more protection against transient voltages than a meter with a lower category rating.

Kyoritsu manufactures electrical testing and measurement instruments such as multimeters, clamp meters, and power quality analyzers. The company, founded in 1940, is headquartered in Tokyo, Japan.

What's in the Box?

• Kyoritsu 2003A digital clamp-meter
• Test lead set
• Output plug
• (2) 1.5V AA batteries
• Carrying case
• Instructions