QAG Flow Hanging Tester Flow Meter Color Paint Flow Meter (50-275um/250-475um/450-675um)

After your order is confirmed,the product will reach you within 7--13 business days.

Test
Test conditions: temperature 23.2 DEGC, relative humidity 50.5%.
Sampling: according to GB3186 Conduct
Should make the flow hanging tester, test plate to keep clean, dry;
Sampling procedure
The base of the tester will be placed on the platform, in the test plate is placed on the base of the appropriate position, the scraping coating is placed in the test panel at the top of the scale face to the operator.
Fully mixing samples will enough amount of samples in the applicator in front of the scraping opening, hold hands scraping sides of two, at one end of the beginning and the leading edge in close contact, smooth, continuously from top to under Guala, also should be kept straight without ups and downs aboutS 2----3Complete the operation process.
Should be scraped off the film test plate immediately placed vertically, should be placed on the film when the film was kept on the thin thickness.
When the coating surface is dried, the flow hanging condition is observed. If the film thickness film is not in the next film thickness, the coating film of the thickness is not hung, and both ends of the coating film are respectively. 20mmInner zone.
Results
Parallel experiments with three samples in the same pattern. The test results in less than maximum wet film thickness of two samples measured by film without sagging (in a consistent representationumMeter)

Attention:
Hanchen Instrument aims to provide great product and service.We are trying our best to satisfy your requirement.
If you have any question, please feel free to contact with us.We are delighted to help you.
Or if you have any suggestion,do not hesitate to tell us.