Techtongda Fine Pole Permanent Magnetic Chuck 6×6 inch For Grinding Machine

Instructions：
Put the workpiece on the suction table, and then insert the wrench into the shaft hole to turn clockwise180°, the workpiece can be sucked for processing.
The workpiece is completed, the wrench can be inserted into the shaft hole to turn counterclockwise 180 °, you can remove the workpiece
Maintenance：
Sucker should be wiped clean before use to avoid scratching the surface, after using, the surface should be coated with oil to prevent corrosion.
Use of ambient temperature: -40 ℃ -50 ℃.
Do not knock, to prevent magnetic reduction.
Strong dense pole permanent magnet sucker is for surface grinder, sparks machine, WEDM.
Very fine spacing, uniform magnetic distribution, particularly for processing small thin parts.
Worktable precision no change while magnetizing and demagnetizing. Panel with special treatment, no leakage, to prevent corrosion of cutting fluid. To prolong service life of the disk, it can be placed on the cutting fluid for storage.Six-surface fine grinding processing, the sucker can be used in  vertical direction on the wire cutting machine cutting. High-performance magnetic steel disk, with suction, almost no remanence. Suction can be 120N / cm2.
Application:
The magnetic chuckcan be used for processing various magnetic conduction work pieces.
For surface grinder, tool grinder, EDM and other applications.
Thin & light weight work piece are ideally suitable because of fine-pitched magnetic poles
Item number: 170424
1 x Hex wrench
4 x Mounting tabs
1 x Magnetic chuck