ETCR LK6200 High Accuracy DC/AC Clamp Leaker Leakage Current Tester with RS232,Measurement of AC/DC Current, Leakage Current, Repairing the Car Circuit,0mA~60.0A AC/DC Measurement Range

Technical Specification:
Measurement Range:0mA~60.0A AC/DC
Resolution:1mA AC/DC
Accuracy:±2%rdg±5dgt (23℃±5℃, below 75%rh)
Test Mode:Clip-on CT, noncontact measurement
Clamp Size:25mmX35mm
Display Mode:4 digits LCD display
LCD Dimension:35mm×21.5mm; display domain: 32mm×15mm
Sampling Rate:2 times/s
Frequency:AC: 45Hz-400Hz
Polarity Indication:DC current auto identified and display"-"
Test Position:Tested wire in the jaw center
Range Shift:Automatically
Line Voltage:Do not exceed AC 600V
RS232 Interface:Data stored in the memory of the meter via RS232 upload to PC
Com-Configure:Baud rate:9600, data bit:8, stop bit:1, check bit: NONE
Data Memory:99 units, FULL blinks when the memory is full
Reading Hold:DH indicating the reading is hold
Out of Range:OL indicating the current is out of range
Auto Power-off:5 Minutes after power on, it will power off automatically to lower the power consumption
Battery Voltage:Indicating the battery voltage is lower than 7.2V.Then the battery have to be changed.
Working Current:10mA
Humiture:-10℃-50℃,below 80%rh
Limit Temperature Error:-10℃-0℃ and 40℃-50℃, within 2%rdg
Humiture Storage:-10℃-60℃,below 70%rh
Insulating Strength:AC 3700V/rms. (between the alloy of the clamp and the housing)
Applicable safety rules:IEC1010-1, IEC1010-2-032, pollution:2, CAT â…¢(600V)