ETCR6200 Clamp Leakage Current Meter Test AC/DC Current Repairing The Car Circuit

It could be widely use in those fields as car repair, car leave factory test, car parts test, the current detection in telecommunication room, electric power overhauling, meteorology, oil detection, etc.

Technical Specifications
Function: Measurement of AC/DC current, leakage current, repairing the car circuit. 
Power Supply: Zn-Mn dry battery,6F22,9V, continuous use for 30h
Test Mode: Clip-on CT, non-contact measurement
Clamp Size: 25mmX35mm
Measurement Range: 0mA-60.0A AC/DC
Resolution: 1mA AC/DC
Accuracy: ±2%rdg±5dgt (23℃±5℃, below 75%rh)
Display Mode: Four digits LCD display
Sampling Rate: 2 times/s
Frequency: AC: 45Hz-400Hz
Polarity Indication: DC current auto identified and display"-"
Test Position: Tested wire in the jaw center
Line Voltage: AC600V
RS232 Interface: Data stored in the memory of the meter via RS232 upload to PC
Com-Configure:Baud rate: 9600, data bit:8, stop bit:1
Data Memory: 99units, FULL blinks when the memory is full
Reading Hold: DH indicating the reading is hold
Out of Range: OL indicating the current is out of range
Auto Power-off: 5 Minutes after power on, it will power off automatically to lower the power consumption
Battery Voltage: Indicating the battery voltage is lower than 7.2V.Then the battery have to be changed
Working Current: 10mA
Consumption: 10mW
Working Temperature and Humidity: -10℃-50℃,below 80%rh
Limit Temperature Error: -10℃-0℃ and 40℃-50℃, within 2%rdg
Storage Temperature and Humidity: -10℃-60℃,below 70%rh
Insulating Strength: AC 3700V/rms. (between the alloy of the clamp and the housing)
Applicable safety rules:IEC1010-1, IEC1010-2-032, Pollution level 2, CAT â…¢(600V)