Power Meters - Page 26

Manufacturer: Dranetz Brand: Dranetz Model: TR-2500B

AC Flexible Current Probe, Amps AC 10 to 500A, AC Frequency Response 40 Hz to 5 kHzMax. Conductor Size 50MM, Connector Type Dranetz Hypertronics Connector, For Use With Mfr. DBPX108, DBPG106, DBPV500, DBPV10, DBPVFLEX, DBMP1, Output 1.5VIncludes 500A Current Probe,

Manufacturer: Hedland Brand: Hedland

Hedland H637X-025-F1 Flow Meter

Manufacturer: UEI Test Instruments Brand: UEi Test Instruments Model: LPKIT

Simple adjustable tic rate - Easy one hand operation - Long 18" gooseneck - Tip light in sensor cover illuminates the area of the leak.

Manufacturer: XiTRON Technologies, Inc. Brand: XiTRON Technologies, Inc. Model: 892-HC-7 Color: Black

The HC-7 - Carrying Case is a hard-sided case designed for the 280x series power analyzer.

Manufacturer: Compliance West Brand: Compliance West

HTT-1R LomA, Function Checker, Ground (Pass 0.1 Fail 0.025 ohm) Leakage (Pass 4.232M, Fail 2.088M) Arcover 750V ± 400V. The HTT-1R was designed to provide a fast, safe and reliable way to verify proper operation of Dielectric Withstand (hipot) and Ground Bond Testers between calibration cycles, using actual component values which mimic the product being tested. It provides a stringent periodic check of your production line hipot and ground bond testers as required by TUV and others. The HTT-1R functions like our successful HTT-1 tester, but goes a step further by providing component values as the test loads, instead of opens and shorts provided by the HTT-1. By choosing one of our standard configurations conforming to your testing parameters (or custom parameters based on your requirements), the hipot and ground bond tester in use are checked by realistic component values which mimic the characteristics of your production items. The HTT-1R verifies the result of the three failure modes encountered in production hipot and ground circuit testing (open ground, high leakage current, and dielectric breakdown) separately or in any combination to verify proper test equipment operation. A passing test can also be simulated. The HTT-1R is designed to test up to 30A ground bond testers using these values to simulate actual operation. Connections to the Ground Bond Tester will add approximately 0.03Ω to these values.

Manufacturer: Dranetz Brand: Dranetz Model: TR-2530B

Ac Clamp On Current Probe, Amps Ac 20 To 300a, Ac Frequency Response 30 Hz To 5 Khzjaw Capacity 2.1 In. (54mm), Max. Conductor Size 2500 Mcm, Connector Type Dranetz Hypertronics Connector, For Use With Mfr. No. Dbpx108, Dbpg106, Dbpv500, Dbpv10, Dbpvflex, Dbpv550, Dbpx108-400, Enc-tr-s, Enc-tr-e, Output 1.5v Full Scale Rms, Accuracy +/-1.5 Percentincludes Instructions,

Manufacturer: DENT Instruments Brand: DENT Instruments Model: CT-R72-1310-U

The DENT RoCoil Current Transformers have been designed for accurate non-intrusive measurement of AC current, pulsed DC or distorted waveforms. This type of sensor may be used to measure AC current over a wide dynamic range and from40Hz to 5 kHz. Note: The RoCoil may require use of integrator/ amplifier. Window Size: 3cm(5"),19cm(7"), 26cm(10"), 58cm(23") Accuracy: < 1%.

Manufacturer: Veris Brand: Veris

Din-Mount, Power and Energy Meter, Data Logging: 10 16 Bit Configurable Data Buffers, 60 Day Readings (15-min Intervals), Alarm Output (N.C.), 1 Pulse Output (N.O.), RS-485 Serial Modbus RTU Protocol, Built-in Rope CT integrator and Power Supply, 5-Year Warranty

Manufacturer: Dranetz Brand: Dranetz Model: DRANFLEX300MHB6

Flexible Probes are available in three lengths 24 inches, 36 inches, and 48 inch lengths and available in two maximum ranges of 3000 A RMS and 6000 A RMS. Each probe can be powered by battery or AC adapter and multiple probes can be powered by a single AC adapter. Flex probes are available as separate probes, or as four phase packages, which include power supply. All Flexible Probes listed here are compatible with Dranetz portable instruments: PowerXplorer, PowerGuide, PowerVisa, PowerGuia, Energy Platform, PP4300, 658 with CA4300 adapter; and Dranetz permanent instruments: Encore 61000 with 61MAC module, Signature System 5513. Adapters are available for use with other instrument configurations; contact us for details. Dranetz recommends only Dranetz-brand probes be used with Dranetz power quality equipment

Manufacturer: DENT Instruments Brand: DENT Instruments Model: ESP-W-US

The ELITEpro SP weather tight enclosure is designed so that a standard ESP can be retrofitted into a weather tight enclosure and can utilize DENT's range of unterminated current transformers. The enclosure is listed to UL 50 and UL 508 and achieved ingress ratings of IP 67 and NEMA 4X, 6 and 6P. The strain relief and panel mount connectors are IP68 rated and the banana jacks are IEC 61010? 031 1KV CAT III rated.