Oscilloscopes & Accessories - Page 77

Manufacturer: Probe Master Brand: Probe Master Model: 4905-1

Oscilloscope probe, 250MHz, 10X, 600V, 3.5ft, BASIC KIT

Manufacturer: Cal Test Electronics Brand: Cal Test Electronics Model: CT3133RA

General purpose series 350 MHz, 10x fixed attenuation oscilloscope probe. Probe features a readout actuator pin (sense pin) on the BNC connector. 350 MHz bandwidth. High impedance input (10 MO/15 pF). 10-35 pF compensation range. 300 V CAT II. Snap-locking sprung hook. Easily replaceable tip. Large accessory set. Meets IEC 61010-031. Accessories included: 15 cm ground lead, replacement tip, black snap-on sprung hook, tip insulator, ic tip, bnc adapter, probe tip ground, trimmer tool and identifier rings. The high performance family is a high quality, general purpose set of 5mm passive voltage oscilloscope probes. They are excellent replacement probes for all makes and models of oscilloscopes. Type: 5 mm passive voltage. Attenuation: 10x. Input impedance: 10 mohm. Input capacitance: 12 pF. Output impedance: 1 mohm. Risetime: 1 ns IEC rating: 300 V CAT II. Compensation: 10-35 pF. Cable length: 1.2 m. Readout actuator: yes. Operating temperature: 0 to +50 degree C. Humidity: 85 percent RH or less (at 35 degree C). RoHS (2002/95/EC) compliant.

Manufacturer: Micsig Brand: Micsig Model: P130

• Attenuation ratio: 1:10 (1X & 10X) Input Resistance: 1MΩ:10MΩ • Bandwidth: 300MHz Rise Time: 1.15ns • Input Capacitance:1M 85pF~115pF, 10M 14.5pF~17.5pF • Compensation Range: 15pF-35pF • Working Voltage:1X:

Manufacturer: JYE Tech Brand: JYETech

Low Cost Fully Assembled Digital LCD Oscilloscope. JYE Tech DSO 062 Includes: 9V Power Supply and simple probe

Manufacturer: Probe Master Brand: Probe Master Model: 4902-1

Oscilloscope probe, 250MHz, 1X/10X, 600V, 3.5ft, BASIC KIT

Manufacturer: GW Instek Brand: GW Instek Model: GSC-006

Soft carrying case for GDS 1000A/GDS-1000 series oscilloscopes.

Manufacturer: Probe Master Brand: Probe Master Model: 4904-3

Oscilloscope probe, 125MHz, 10X, 600V, 6.6ft, BASIC KIT

Manufacturer: Fluke Corporation Brand: Fluke Model: L211

kit includes L200 probe light, TL71 premium DMM test lead set and C75 case. Special value combo pairs the new L200 probe light with one of the most popular test leads by Fluke and a handy carrying case. Small, rugged light easily attaches to any Fluke test probe. Flexible silicone test leads are heat and cold resistant. Zippered case has two inside pockets. Probe light frees both hands for work. 120 hours of battery life. Uses 2 3-volt watch batteries.

Manufacturer: Cal Test Electronics Brand: Cal Test Electronics Model: GE3122

The GE Series is a high quality, easy to use family of 5mm passive voltage oscilloscope probes in stylish, slim-line bodies. The series features superior input impedances for enhanced measurement performance when compared to other oscilloscope probes. It is a high bandwidth, high voltage 100x passive voltage probe with a 100 mohms input impedance. Bandwidth : 100 MHz. Attenuation: 100x. Input Impedance: 100 mega ohms. Input Capacitance: =6 pF. Output Impedance: 1 mohms. Risetime : 3.5 ns. IEC Rating: 2,000 Volt CAT I. Compensation: 10-30 pF. Cable Length: 2.0 meter Voltage Coefficient (VCR): =30 ppm/V (6 percent). Operating Temperature: 0 to +50 degree C. Humidity: 85 percent RH or less (at 35 degree C). RoHS (2002/95/EC) Compliant.

Manufacturer: Hantek Brand: Hantek6022BE

Hardware Specification Channel:2 Channels Bandwidth:20MHz Input Impandence:1MΩ 25pF Max. Sample rate:48MS/s Vertical resolution:8Bit Gain range:20mV-5V, 8Steps DC accuracy:±3% Coupling:DC Timebase range:1ns-9000s, 39 Steps Vertical adjustable:Yes Input protection:Diode clamping X-Y:Yes Trigger Mode:Auto, Normal and Single Trigger Slope :+/- Trigger level adjustable:Yes Trigger Type:Rising edge, falling edge Trigger Source:CH1, CH2 Pre/Post trigger:0-100% Sampling selection:Yes Waveform Display: port/line, waveform average, persistence, intensity Network:Open/Close Vertical mode:CH1, CH2, Dual, ADD Cursor measurement:Yes Math: FFT, addition, subtraction, multiplication, division. Cursor: Frequency, Voltage Accessories:S/W CD, probes, manual, USB cord 3.Software Operating system: Windows 7, Windows NT, Windows 2000,Windows XP, VISTA 4.Second Design Supply DEMO code(VC、VB、LABVIEW) and technical support.