Voltage Testers - Page 28

Manufacturer: Fluke Corporation Brand: Fluke Model: STL120-III

Set of two (one red, one gray) double insulated silicone shielded test leads for noise free measurements. Specially designed for use with the Fluke ScopeMeter 120 series. Compatible with AC120 alligator clips and HC120 hook clips. Safety designed ground leads included. Integral strain relieve and extra hard probe tips provide extra long service life. Features safety designed shrouded plugs and notched tip to prevent probe from sliding. Bandwidth: 12,5 MHz. Maximum signal voltage: 600V rms, CAT III per IEC 61010-031:2008. Maximum voltage to ground: 600V rms, CAT III per IEC 61010-031:2008. Maximum current: 1A. 2mm Add-on test pin: 600V, CAT II per IEC 61010-031:2008. Length: 1.2m.

Manufacturer: Fluke Corporation Brand: Fluke Model: FLUKE-FP Color: White

The Fluke FoodPro infrared thermometer takes noncontact temperature measurement and is used to monitor the surface temperatures of food products and foodservice equipment. This thermometer measures temperature from -30 to +200 degrees C (-20 to +390 degrees F) with an accuracy of + or - 1 degree C (+ or - 2 degrees F) from 0 to 65 degrees C (32 to 150 degrees F) and + or - 1.5% of the reading above 65 degrees C (150 degrees F). It has a 2.5:1 infrared distance-to-spot ratio with LED illumination for highlighting the measurement area. Go/No-Go lights indicate when food is in an unsafe temperature range (40 to 140 degrees F) to meet Hazard Analysis of Critical Control Points (HACCP) guidelines. It is Ingress Protection certified IP54 for dust and splashing liquid and can be hand washed without submersion after use. The CE mark indicates compliance with applicable European Union (EU) directives. It comes with one AA battery and instructions. This thermometer is used by foodservice professionals to measure food product and equipment temperatures and help detect potential food safety problems.SpecificationsTemperature range-30 to +200 degrees C (-20 to +390 degrees F)Infrared sensor accuracy0 to 65 degrees C (32 to 150 degrees F): + or - 1 degree C (+ or - 2 degrees F); above 65 degrees C (150 degrees F): + or - 1.5% of the reading; below 0 degrees C (32 degrees F): + or - 1 degree C (+ or - 2 degrees F) + or - 0.1 degreeDisplay resolution0.2 degree C / 0.4 degree FDistance-to-spot ratio2.5:1Working range25 to 250mm / 1 to 10 inchesPower SupplyAA batteryWeight100gDimensions150 x 30 x50mm (H x W x D)H is height, the vertical distance from the lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.Digital infrared thermometers measure the temperature of surfaces from a distance. They may measure temperature in Celsius, Fahrenheit, or both. Infrared (IR) thermometers work by focusing the infrared radiation emitted by a surface onto a detecto...

Manufacturer: Fluke Corporation Brand: Fluke Model: T5-H5-1AC KIT/US Color: T5-H5-1AC Electrical Tester Kit

This kit is designed to help electricians and HVAC technicians solve problems quicker. Test first for overheated electrical devices using an IR thermometer; then use electrical test tools to find out more about the problem.

Manufacturer: HOYT ELECTRICAL INSTRUMENT Brand: Materro(tm)

Manufacturer: Fluke Brand: Fluke Model: 4472387 Color: Yellow

Pin continuity Test: Tests if filaments have continuity. Ballast-type Test: Determine if ballast is electronic or magnetic without taking fixture apart – identify energy wasting ballasts.

Manufacturer: JINHEZO Brand: JINHEZO Model: na Color: 6 PCS White

To protect your batteries, get this Clear Color 6 PCS of AA / AAA 4 Cell Battery Storage Case.

Manufacturer: DROK Brand: DROK Model: 090079

Technical Parameters: Dimension: 48×29×22mm Cutting size: 46×27mm Measuring voltage range: DC 3-30V Maximum input: DC 30V (if the input voltage is higher than DC30V, the voltmeter will be burnt) Minimum input: DC 3V (if the input voltage is lower than DC 3V, the value will be inaccurate or not displayed) Measurement accuracy: Less than 10V, accurate to 0.01V; More than 10V, accurate to 0.1V (allowable tolerance: 1% +/- 1 word) Display: 3 digit 0.56'' LED digital tube Font Color: Green Refresh rate: about 200mS No need power supply Consuming current: less than 20mA (generally 5-15mA) Operating temperature: -10°c-65°c Wire length: 20cm Reverse connection protection: YES Method of wiring: Red wire: Positive Black wire: Negative Note: Please don't use this meter in 24V battery because when the battery is full-charged, its voltage will be about 30V (the max input volt for this meter), and we don't suggest you use it in max volt of 30V. Package Includes: 1× 0.56'' Voltmeter

Manufacturer: Amprobe Brand: Amprobe Model: 4589825

Battery failure is one of the most common causes for sensor or instrument failure. Battery Tester indicates the amount of charge remaining in standard and rechargeable batteries.

Manufacturer: SMAKN Brand: SMAKN

weight: 16g Display color: Red/Yellow/Blue/Green/White Display mode: Three 0.56 LED digital tube update rate: About 500 ms/time Physical size: 48 x 29 x 21.5 mm (L*W* H) Opening size: 45.5 x 26 mm (L*W) Power supply: Don't need the power supply, direct use of the test voltage as a power supply Lead wire length: 14 cm The minimum input: 3.50V The maximum input: 30.0V Measurement range: DC3.50 - 30.0V Operation temperature: -10 degrees~65 degrees Measurement accuracy: ±(5‰ + 2 Digit) Red line:Power Supply +,Measure Voltage +,(3.50-30.0V DC) Black line:Power Supply -, Measure Voltage- Note:Because the truck battery is fully charged voltage of about 28V. Especially when the truck starts immediately, the pulse interference is likely to damage the module. This table does not fit 24V truck. So if you counter this situation, please select the 15-80V voltmeter.

Manufacturer: DROK Brand: DROK Color: Green

Features: Cutting size: 23mm x 14mm Thickness: 10mm Mounting Hole Center Distance: 28mm Measure Voltage:  DC 2.7~30V (No Need power supply, measure Directly) Input Polarity: DC Voltage Measurement Accuracy: 1% (+ / - 2 digit) Display: Three 0.36" digital LED Tube Display Color: Green Refresh Rate: about 500mS / times Operating Temperature: -10°c ~ 65°c Reverse protection: have when measure 10V below:  the voltmeter display x.xx when measure more than 10V, the voltmeter display xx.x Wiring: Red: Power Supply +,Measure Voltage +,(3.0 ~ 30V DC) Black: Power Supply -, Measure Voltage - Some applications: Measure 18650 batteries Measure Cell-phone Lithium Batteries Measure Nickel-hydride Battery Pack Measure Cars Motorcycles Battery Voltage,Etc. Package Includes: 1x Digital Panel Voltmeter