Flowmeters - Page 14

Manufacturer: JGB Enterprises Brand: Universal Flow Monitors Model: IS-50 GPM-12-F-F

This flowmeter is made of materials that allow use in various levels of ultrapure water. The clear plastic tube is made from Polysulphone. The spring and shaft material are 316 Stainless steel. Seals are optionally Viton or Kalrez. End fittings are made from either 316 Stainless or PVDF. Insite-Inline Flow Meters made of see-through plastic with metal or plastic port adapters. You get to see your fluid as well as having all metal pipe connections. These are used for water, compressed air, dilute chemicals (such as those used in water treatment), and de-ionized water.

Manufacturer: Testo AG Brand: Testo Model: 0563 4170

Flow funnel kit for low flow measurements.

Manufacturer: Racine Federated Brand: Hedland Model: H605B-010

Flow Meter For Water and Other Liquids. Direct reading. Install in any position. 360 degrees rotatable guard/scale. Easier-to-read linear scale. No flow straighteners or special piping required. Relatively insensitive to shock and vibration. Good viscosity stability. Temperature up to 240 degrees F. Accuracy +/-2 percent full scale. Repeatability +/-1 percent. Special scales available. Calibrated for 1.0 S.G. Materials: C360 Brass body, piston and cone. Common parts are Spider Plate: T316 SS, Spring: T302 SS, Fasteners: T303 SS, Pressure Seals: Viton, Guard: Polycarbonate, Retaining Ring: T316 SS, Retaining Spring: T316 SS, Indicator and Internal Magnet: PPS / Ceramic, Guard Seal / Bumper: Buna N, Scale Support: 6063 - T6 Aluminum and End Caps: Nylon ST.

Manufacturer: GPI Brand: GPI® The Proven Choice® Model: A109GMN100NA1

The GPI model A109GMN100NA1 is a 1" Nylon A1 Flowmeter. This 1" nylon flowmeter with NPT fittings and electronic digital LCD that reads in gallons. This flowmeter can be installed on your water hose.

Manufacturer: MISOL Brand: MISOL

Description: This listing includes 1 unit of flow meter. Working principle: When the water flows through the rotor, then rotor is rolled.Its speed changes with different rate of flow. Then the magnetic rotor make reaction to Hall sensor,The hall-effect sensor outputs the corresponding pulse signal. The flow sensor is suitable to detect the flow rate. Specification: 1. Thread size :DN20, G3/4" (BSP),male. 2. Voltage: DC4.5-18v. 3. Body Material: brass 4. Flow rate : 2~45L/min. 5. Flow Pulse: F(Hz)=8.1*Q - 3(+/-10%) Q=L/min 6. Max. Working Current : 10mA (DC5 V) 7. Min. Working Voltage: DC 4.5V 8. Working Voltage: DC 4.5V~18V 9. Load Capacity: =10 mA (DC 5 V) 10. Insulation resistance: over 100M Ohm 11. Max pressure: 1.75mpa 12. Suitable for liquid : water.(less than 60 cel. degree)13. Flow hole: 14mm (diameter)

Manufacturer: Gems Sensors Brand: Gems Sensors Model: 155870

Standard kit for 1/4" and 1/2" plastic RFO/RFS/RFA RotoFlow Series Sensors. This kit includes rotor, O-ring and lens only for plastic body only.

Manufacturer: uxcell Brand: uxcell

Acrylic body, stainless steel float and leader, plastic thread ends, inline mounting type.3/4" female thread, 0.2-2.0 GPM range, 1-7 LPM range.Widely used for residential and industrial applications.

Manufacturer: uxcell Brand: uxcell

Flowmeter measuring the oil or water, easy to read for its clear scale.Straight tube style connect the liquid tube by two male connector.Stainless steel material inner and glasses tube design.

Manufacturer: Dwyer Instruments Brand: Dwyer Model: RMA-32-SSV

line of direct reading precision flowmeters incorporates many unique user features at moderate cost. These low cost flowmeters are ideal for general use.

Manufacturer: Dwyer Instruments, Inc. Brand: Dwyer

Dwyer® Series WM2 Multi-Jet Water Meter is ideal for commercial and industrial applications. The multi-jet design allows for simplicity and accuracy with wide flow ranges, even in low flow applications. The magnetically driven, hermetically sealed register will not leak or fog and is completely separated from the water. These water meters are designed for long service life and maintenance-free operation, even under harsh conditions. Note: NOT FOR POTABLE WATER USE, BRASS CONTAINS LEAD IN EXCESS OF LOW LEAD LIMITS. (Standard range shown in picture).