Capacitance & Resistance Meters - Page 17

Manufacturer: Zhangzhou Eastern Intelligent Meter Co. Brand: all-sun

Introduction This instrument is accurate, reliable and easy to operate. For insulation resistance test, you can change the test voltage among 250V 500V and 1000V. It can also be used to test ACV, resistance which is less than 200Ω, and test for continuity. You can use it to test transformer, motor, cable, switch, electrical appliance as well as to do insulation resistance test. Specification Display: 3 1/2 digits LCD, with max. reading 1999 Low Battery Indication: "-+" shown on LCD Power Supply: 1.5V, AA battery, 6 units Operating Temperature: 0℃ to 40℃,

Manufacturer: Megger Brand: Megger Model: 1000-525

The Megger 6220-805 earth test cable set is a replacement cable set for conducting ground resistance tests with a Megger DET3 series ground resistance tester (sold separately). The set includes a 15m red wire, 10m yellow wire, and 4m green wire to replace the original wires included with the tester. The 6220-805 is an accessory for use with a Megger DET3 series ground resistance tester.Megger manufactures equipment for cable fault locating, protective relay testing, telecommunications and data integrity, and power quality testing under multiple brand names, among them Megger, Biddle, States, and AVO. The company, founded in 1889, is headquartered in Dover, England, and meets International Organization for Standardization (ISO) 9001:2008 standards.

Manufacturer: ifm electronic gmbh Brand: IFM Efector Model: KI5207

Capacitive Sensor, M30 X 1.5, Plastic Thread, Sensing Range: 15 Mm, Non-Flush Mountable, 3-Wire, Dc Pnp, Operating Voltage: 10...36V Dc, Current Consumption: 13 (24V) Ma, Normally Open/Closed Programmable, Cable, 2 M, Pvc Cable, 3 X 0.5 Mm², Increased Immunity To Conducted Radio Frequency Interference, Housing Material: Pbt.

Manufacturer: Zhuhai Jida Huapu Instrument Co.,Ltd Brand: HoldPeak

Product Description： Earth Ground Resistance Tester Kit - HP-4300 Includes all hardware necessary to measure earth ground in 3 ranges from 20 to 2000 Ohm Specification： Earth Voltage: 200V Voltage accuracy: 1.0%+4dgt Earth resistance: 20ohm/200ohm/2000ohm Resistance accuracy: 2.0%+0.1ohm/2.0%+3dgt Display: 1999 Range select: Manual Data hold Low battery indication Auto back light HV indication lamp ligh Battery supply: 6*1.5V(AA) Dimension: 218*122*75mm Weight: 900g From the Manufacturer： Earth Ground Resistance Tester measures in 3 ranges from 20 to 2000 ohms. Additional measurements include: AC/DC Voltage, Resistance and Continuity. Comes complete with test leads, 2 auxiliary earth bars, carrying case, rubber holster, and six AA(1.5V) batteries.

Manufacturer: NTE ELECTRONICS Brand: NTE Electronics

NTE ELECTRONICS CX-920A DIGITAL CAPACITANCE METER

Manufacturer: Megger Brand: Megger Model: 21963H

The Megger 2-piece lead set is a set of replacement test leads for conducting insulation resistance tests with a Megger 210170 or 210600 insulation tester (sold separately). The lead set includes two, 1.8m (6’) test leads. The 2-piece lead set is used to conduct insulation resistance tests with Megger 210170 and 210600 insulation resistance testers. Megger manufactures equipment for cable fault locating, protective relay testing, telecommunications and data integrity, and power quality testing under multiple brand names, among them Megger, Biddle, States, and AVO. The company, founded in 1889, is headquartered in Dover, England, and meets International Organization for Standardization (ISO) 9001:2008 standards.

Manufacturer: OUTEST Brand: OUTEST

Manufacturer: OUTEST Brand: OUTEST

Manufacturer: Peakmeter Brand: PEAKMETER

Product Description: Large digital LCD and backlights applied to the meter facilitate users to read the information on LCD. Besides, the meter is capable of storing up to 100 groups of measurement data, which will not be lost even in case of power cuts so that the user can easily consult the historical data. In addition, the meter can also be used to measure maximum, minimum or average and measure relatively. Auto power-off function has been provided for it. Product Features: »Digital Display & Analog Bars Display »2 Pole and 3 Pole Mode »Earth Resistance By Constant Current Inverter 800Hz/3mA »MAX/MIN/AVG/REL Measurement Functions »Data Logging:100 group »Display Back Light »Low Battery Indication » Auto Power Off Product Specification: Resistance: 0Ω～29.99Ω ±(2%+6dgt) 0.01Ω 30Ω～99.9Ω ±(3%+3dgt) 0.1Ω 100Ω～999Ω ±(3%+3dgt) 1Ω 1.00kΩ～4.00kΩ ±(3%+3dgt) 10Ω Earth voltage: 0V～200V(50～60Hz) ±(1%+5dgt)) 0.1V Power Supply: 6x1.5v AA batteries Product Size: 180mm x 140mm x65mm (7.1" x 5.5" x 2.6") Product Weight: 950g(20lb) Category: CE ETL CAT.Ⅲ1000v Packing size: 340*265*103mm Packing weight: 3000g Package include: 1*MS2302 DIGITAL EARTH RESISTANCE TESTER 1*Colorful Box 1*User Manual 1*Holder 1*Rubber sleeve 1*Meter bag 1*Alligator clips 1*Test cable 1*Signage 1*Sponge mats 1*Static filmKindly notice: As HYELEC is our old brand, and the new brand is PEAKMETER, but we still has the items which the brand is HYELEC, so the item we sent will include PEAKMETER and HYELEC, but please do not worry about it, we guarantee these item 2 logo are the same products.

Manufacturer: UNI-T Brand: UNI-T

Insulation Resistance Tester UT511 FEATURES: Low Battery Indication Data Logging: 18 Polarization Index(PI) Dielectric Absorption (DAR) LCD Backlight SPECIFICATIONS: Model: UT511 Insulation Resistance(?): Test Voltages: 100V/250V/500V/1000V 0%?20% ;100V 0.1M?~500M? ±(3%+5); 250V 0.5M?~2G? ±(3%+5); 500V 1M?~4G? ±(3%+5);1000V 2M?~10G? ±(3%+5) Short Circuit Current?