Capacitance & Resistance Meters - Page 8

Manufacturer: Megger Brand: Megger Model: MIT40X-EN

The Megger MIT40X series insulation tester is an insulation resistance meter with built-in voltmeter for measuring insulation resistance, voltage, and continuity in commercial avionics, military communications, component, and other special-use systems. The autoranging digital meter includes true root mean square (TRMS) and direct current (DC) voltage measurement. The unit has variable test voltages from 10 to 100V in 1V steps. The tester measures insulation resistance from 2 to 20 gigaohms, continuity from 0.01 to 100 ohms, and voltage from 0 to 600V. The dual LCD screen indicates test results either digitally or with an analog arc function to replicate the response of analog meters. The unit has a voltage detection test inhibit feature prevents testing when a circuit has a voltage of greater than 50V. The tester is safety rated to European Standard EN61010-1, Category IV, 600V and is also Ingress Protection 54 (IP54)-rated for protection against dust and splashing water. The Megger MIT40X is used by electricians and electrical contractors.Specifications Test voltages 10 to 100V in 1V steps Automatic continuity testing range 0.01 to 100 Ohms (0-50 Ohms on analog range) Voltage testing range 0 to 600V DC or TRMS Voltage test inhibit level 50V Power supply 5 AA alkaline or rechargeable batteries Weight 590g / 20.73oz. Safety standard met International Electrotechnical Commission (IEC)/European Standards (EN) 61010-1 Cat IV 600V Mechanical standard met IP54, for protection from dust and splashing water Dimensions 220 x 92 x 50mm / 8.66 x 3.63 x 1.97 inchesH is height, the vertical distance from the lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.Electrical test meters report electrical circuit properties, such as voltage, resistance, capacitance, and continuity. Available in handheld or benchtop form, they detect electrical problems in equipment, wiring, and power supplies. A variety of probes, clamps, and lead...

Manufacturer: AEMC Brand: AEMC

The Ground Resistance Tester Model 6416 measures ground rod and grid resistance and impedance without the use of auxiliary rods and can be used in multi-grounded systems. Thanks to its clamp-on capability, it can be used without disconnecting or de-energizing the ground system being tested.

Manufacturer: Extech Instruments Brand: Extech Model: MG500

Digital High Voltage Insulation Tester The MG500 is a CAT III-300V insulation tester capable of performing voltage tests up to 10 kilovolts (500 volts to 10 adjustable in 500 volts steps), with insulation resistance from 800 k to 500 GΩ (autoranging) plus, polarization index (PI) measurement and dielectric absorption ratio (DAR) measurement. The MG500’s EnerSave function limits test duration to 10 seconds to conserve battery power. What's in the Box Comes complete with built-in heavy duty carrying case, test leads, alligator clips, eight C-size batteries, and user manual. Specifications Insulation Resistance = 1M, 2M, 10M, 20M, 100M, 200M, 2G, 20G, 100G, 500GΩTest Voltages = 500V, 1000V, 2500V, 5000V, 10000VPolarization Index = YesDielectric Absorption Ratio = YesVoltage Output Warning = YesAutomatic Discharge = YesDimensions = 13 x 10.2 x 6.3 inches (330x260x160 mm)Weight = 7.9 pounds (3.6 kg)

Manufacturer: Megger Brand: Megger Model: 1001-289

The Megger BM5200 tester is a battery powered instrument with digital and analogue arc display, designed for high voltage insulation resistance testing in the maintenance and servicing of cables, rotating plant machinery, transformers, switchgear and industrial installations.

Manufacturer: Megger Brand: Megger Model: 6410-920

The Megger MJ15 5kv insulation resistance tester measures insulation resistance and voltage in electrical installations, building maintenance, and telecom systems. This analog meter has manual test voltage selection for flexibility of use. The unit is powered by a hand-cranked generator or 8 AA batteries so that it always has a power source. The unit has four test voltage options at 500, 1,000, 2,500, and 5,000V. The unit measures insulation resistance from 100 kilohms to 20 gigaohms and voltage from 0 to 600V alternating current (AC). The tester is safety rated to European Standard EN61010-1, Category III, 300V and Category I, 600V. The Megger MJ15 is commonly used by electricians, electrical contractors, and telecommunications workers.Specifications Power supply 8 AA batteries or hand-cranked generator Voltage testing range 0 to 600V AC Test voltages 500, 1,000, 2,500, and 5,000V Insulation resistance range 100 kilohms to 20 gigaohms Weight 1.2kg / 2.6 lb. Safety standard met International Electrotechnical Commission (IEC)/European Standards (EN) 61010-1 Cat III 300V, Cat I 600V Dimensions 220 x 160 x 115mm / 8.9 x 6.3 x 4.5 inchesH is height, the vertical distance from the lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.Electrical test meters report electrical circuit properties, such as voltage, resistance, capacitance, and continuity. Available in handheld or benchtop form, they detect electrical problems in equipment, wiring, and power supplies. A variety of probes, clamps, and leads can be used to connect the meter to a circuit or device. Single-function meters, such as battery testers and voltage testers, measure one property of a circuit, and multimeters measure multiple properties. Electrical test meters display information either in analog form using a needle that moves on a calibrated scale, or in digital form using digits or a graphic representation on an LED screen. Meters have electrical properties...

Manufacturer: Abcstore99 Brand: Abcstore99

Main Function: 1. One key measurement operation, auto power off delay. Shutdown current is only 20nA, support for battery operation 2: Automatic detection of PNP and NPN bipolar transistor, N, P-channel MOSFET, JFET field effect transistors, diodes, two diodes, thyristors, resistors, capacitors, inductors. Automatic detection of current amplification factor (B) Pin Definitions and turn-on voltage of the transistor and the emitter junction (Uf), Darlington transistor through a high threshold voltage and high current gain recognition. 3: Can detect bipolar transistors and MOSFET internal protection diode and displayed on the screen. It can be measured threshold voltage and the gate capacitance of the MOSFET. 4: Support two resistance measurements, the potential can also be measured. The highest resolution is 0.1 ohm resistance measurements, the highest measured value of 50M Euro. 5: Capacitance measurement range from 25pf to 100mF (100,000 UF). Resolution up to 1 pF. 0.09UF capacitance can be detected above the equivalent series resistance (ESR), a resolution of 0.01 ohms. To display the value of the capacitor voltage loss and increase the capacitance of a separate line ESR measurements, available online (on the circuit) direct measurement capacitor value and ESR, easy maintenance and troubleshooting capacitance. 6. Inductance measurement range of 0.01MH-20H, otherwise it will be displayed as resistance, if the inductor DC resistance higher than 2100 will be displayed as the European resistance. 7. Can two diode display symbols in the right direction, displaying the forward voltage drop. LED detected as a diode forward voltage drop higher than normal. Dual LEDs detected as double diode. Simultaneous detection LED flashes, very intuitive. 8. Each test of time is about two seconds, only the large capacitance and high inductance measurements will take a long time

Manufacturer: BAYM Electric Co., Ltd Brand: BAYM Model: BM35SA

5(80)A 120V 60Hz Single phase Two Wire Din rail KWH Watt hour din-rail energy meter LCD KWH 80A BM35SA Application Model BM35SA single phase electronic DIN rail active energy meter is a kind of new style single phase two wire active energy meter,it adopt micro-electronics technique,and imported large scale integrate circuit, use advanced technique of digital and SMT techniques,etc. The meter completely accord with relevant technical requirements of class 1 single phase active energy meter stipulated in international standard IEC 62053-21 It can accurate and directly measure 60Hz active energy consumption from single phase AC electricity net. This meter has white backlight source eight digits LCD displays shows the active energy consumption. It has following features:good reliability,small volume,light weight,specious nice appearance, convenient installation,etc. Functions and features 35mm standard DIN- rail installation,complying with standard DIN EN50022. Bipolar width (Modulus 17.5mm),complying with standard DIN43880 Standard configuration 7+1 digits display (9999999.1kWh) by white backlight source LCD.May select 7+1 digits display (999999.1kWh) without backlight source general LCD Standard configuration pulse output passive (polarity),may select distant pulse output passive ( nonpolarity).And contact with all kind of AMR system conveniently,Complying with standard IEC 62053-31 and DIN 43864 Two LED instructions power supply state (green) and signal of energy impulse (red) Automatic detection the direction of the flow of load current. And instructions on LCD (when display HELP 1 on LCD,that is meaning the direction of the flow of load current reverse) Single direction measurement single phase two wire active energy consumption.It is nothing with direction of the flow of load current.Complying with standard IEC 62053-21. Directly type S connection

Manufacturer: CROMPTON Brand: Crompton

1 Nib Crompton 217-01-Vaxxx Tachometer Panel Meter 0-1800Rpm (Rr7-2)

Manufacturer: SODIAL(R) Brand: SODIAL(R) Color: Red + Black

* SODIAL is a registered trademark. ONLY Authorized seller of SODIAL can sell under SODIAL listings. Our products will enhance your experience to unparalleled inspiration. SODIAL(R)Cable Tester Cable Detectors Cable Tracker Network Tester Pipe Locator RJ45 Red+Black Color: Red + Black Packing dimension: approx. 23.5 x 23.5 x 8.5 cm Audio Test and Cable Test: open, short, connector, reverse wiring, cross wiring; Positioning incorrect wiring; Cable length measurement; The measure distance of open circuit and short-circuit. delivery: 1 x main tester 1 x receiver 1 x remote detection device 1 x RJ45 network cable 1 x alligator clips cable 1 x instruction manual 1 x headphones 1 x battery 1 x tool bag Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3 cm.

Manufacturer: WILBAC Brand: Wilbac

1 Nib Wilbac 18940 Panel Meter 0-250Vac (X6-1)